RF Demodulators
RF demodulators take a modulated radio frequency signal and recover the baseband information it carries. On this page you will mostly find quadrature (IQ) demodulators, which split a signal into in-phase and quadrature components, along with AM, FM, and phase demodulator ICs aimed at narrower legacy tasks. The IQ parts dominate because modern receivers, whether a cellular base station, a satellite terminal, a point-to-point microwave link, or a spectrum analyzer, almost always move to complex baseband as early as possible in the chain. You will also see parts marketed as RF-to-baseband or direct-conversion demodulators, which do the same job with an integrated mixer and local oscillator interface. When engineers and buyers source these parts, the datasheet numbers that matter are operating frequency range, conversion gain, input IP3 and P1dB for linearity, noise figure, and LO drive level. Matching between the I and Q channels, gain and phase balance, decides how clean the demodulated constellation looks, so that spec gets a hard look on anything carrying high-order QAM. Package is the other practical point: most of these ICs come in small QFN or TSSOP outlines, and many older broadcast and video demodulators have gone end-of-life, which is exactly where an independent distributor earns its keep. On the purchasing side, there is a real trade-off to weigh. Factory-direct franchised stock is the safe route, but lead times on niche RF parts can stretch past 20 weeks. Spot-market availability solves the schedule problem, though it raises counterfeit and relabeling risk, especially on discontinued part numbers. Ask for traceability paperwork, date codes, and photos before committing. Full reels versus cut tape also matters more than people expect, since some assembly houses will not accept short tapes on fine-pitch QFN. Current stock and pricing for the parts listed here are available on request at icxing.com. Send the part number and quantity, and we will come back with what we can actually ship.
Frequently Asked Questions
The RF demodulator I need is listed as obsolete by the manufacturer. Can you still supply it, and how do I know it is genuine?
Discontinued RF parts are a large part of what independent distributors handle, and we can often source them from sealed factory stock or excess inventory. Every lot goes through visual inspection, marking and date code verification, and can be sent for third-party X-ray or decapsulation testing on request. We share traceability documents before you pay, so you can judge the risk yourself.
What is the typical lead time if the part is not in your warehouse?
For stock we hold, shipment usually goes out within 1 to 3 working days after order confirmation. Sourced items typically take 1 to 3 weeks depending on where the inventory sits, while franchised or factory orders on niche RF parts can run 12 to 20 weeks or more. We will quote both options when they exist so you can weigh price against schedule.
Do you supply RF demodulators on full reels, or can I order cut tape for prototypes?
Both. Production quantities normally ship as factory-sealed full reels in the original QFN or TSSOP packaging, which is what most contract manufacturers prefer for fine-pitch parts. For prototypes and small builds we can provide cut tape with a minimum quantity, though pricing per unit is higher and some parts are only available in reel quantities.
- LO Frequency：
-
- Package / Case：
-
- Supplier Device Package：
-
- Filter：
| Image | Part | Manufacturer | Description | Stock | Action | |
|---|---|---|---|---|---|---|
|
CML Microcircuits | IF/RF QUADRATURE... |
6,120
In-stock
|
Inquiry | ||
|
|
CML Microcircuits | QUADRATURE DEMOD... |
3,970
In-stock
|
Inquiry | ||
|
|
CML Microcircuits | RF QUADRATURE MO... |
4,460
In-stock
|
Inquiry |